pen plotter parameter setting

The factory setting of the pen plotter

First enter into the vendor settings,

push down the Scale key and the setting key at the same time 10 seconds, then can enter to the vendor setting.

 Set1: DX +(-), press up and down button to select the + or -, which adjust the running direction of the motor (pen holder system motor)
 
Set2: DY +(-), press up and down button to select the + or -, Which adjust the running direction of the motor( the feeding paper motor)
 
Set3: UR (Auto)

Set4: PP (090), press up and down button to select the figure ,
which adjust the pen pressure, generally adjust between 060-095.
 
Set5: PT (006), press up and down button to select the figure which adjust the pen write speed, the greater the figure the more slowly, the smaller the faster.

Set6: MX (040), press button to select the figure, this is to adjust the number of the motor teeth(pen holder system motor).

Set7: MY (020), press up and down button to select the figure, adjust the number of the motor teeth.(feeding paper motor)

Set 8: FX (500), press up and down button to select the figure, adjust the pen holder system running speed ( runnig without print)

Set 9: FD (1200), by up and down button to select the figure, adjust the plotting speed.

Set 10: SX (070), press up and down button to select the figure, adjust the speed of the machine drawing

Set 11: GX (600), default
Set 12: GY (600), default

Set 13: EY (000), the gap between every marker file

Set 14: Chinese and English switch